Click here for "Safe Air Conditioner Repair and Proper Freon Recovery".

RockyLinux 9 ; SSH、firewalld 、NTP Server

1.Remote connection via SSH

SSH is a service for connecting remotely to a server and is basically running immediately after the OS is installed, but the default settings are somewhat insecure.
Here we will configure the default settings to increase the security of ssh connections.

1.1 Edit SSH service configuration file

Modify the configuration file to change the SSH service settings.
The SSH service configuration file is "/etc/ssh/sshd_config".

Line 21 "Port 22" This time change to "Port 2244" and proceed
Delete the "#" in line 24 "#ListenAddress 0.0.0.0"
Line 41, "#PermitRootLogin prohibit-password", delete "#".
Since the root user already knows the user name and can log in to the server with administrator privileges once the password is known, the setting is set to deny this.

Restart SSH

If this is not done, the next time you reboot, you will not be able to connect remotely via SSH. Please free SSH port 2244 in the following firewall settings.

2.Firewall (firewalld) settings

The firewall is set to firewalld as default and is enabled during OS installation.

2.1 How to use the "firewall-cmd" command to control "firewalld

1)Command to check the status and settings of "firewalld"

Check firewalld operation status

OR

➁View default zone settings
In the above example, we can see that the services "cockpit", "dhcpv6-client", "ssh" are allowed, etc.

③About the "--permanent" option
To prevent the settings from disappearing when the server is restarted or the "firewalld" service is restarted, the
The "--permanent" option must be used to configure the settings.
If the "--permanent" option is specified, the setting is not reflected in "firewalld" as it is, so it is necessary to use "fiewall-cmd --reload" to reflect the setting.

As an example, to use the HTTP service permanently without initialization even if the system is rebooted

④How to start/stop

Since "firewalld" is controlled by "systemd", use the "systemctl" command to start and stop it.

2.2 Allow modified SSH port 2244

2244 ports have been added

3.Remote connection from Windows

Setup in Windows

Start setting up a remote connection from Windows, using "Tera Term" as the terminal emulator.
Start Tera Term, cancel the startup screen, and then select "New Connection" from "File" in the Tera Term menu.

Enter your own settings in the "Server IP Address" and "TCP Port Number" fields. Finally, click "OK.

Click "Continue" on the security confirmation screen.

Enter "User name" and "Passphrase" and click "OK" on the next screen.

If the information is correct, you should be able to log in normally as shown below.

4.NTP Server

Build an NTP server to synchronize the server time with Japan Standard Time

①Chrony Installation and Configuration

②Restart chrony and enable chrony after system reboot

③NTP port allowed in firewall

④Check chronyd status (behavior)

If it is marked with *, it has been synchronized.

タイトルとURLをコピーしました